Thread: help mazorx hall sensor setup on AEM S2

Hi GUYS..
I own S14 with SR20VET and am having a little problem with my mazworx hall sensor setup on my aem ems s2 (30-6601)..u guys would be very helpful if u lead me to the right setup in the ems however this is how I setup the ems and after dataloging with few pulls I find timing errors espically when the car hits full boost..btw am using LS1 coils

Cam/Crank setup:
Fuel teeth 12
Spark teeth 12
Ing range 1.50
Tooth time min 50
Crank alt fire OFF
Crank alt invert OFF
Ing +1/4 tooth OFF
Ing cycle = 1rev OFF


Cam/crank edge triggers:
Crank falling edge OFF
Crank rising edge ON
Cam(T2) falling edge OFF
Cam(T2) rising edge ON
T3 falling edge ON
T3 rising edge ON
T4 falling edge OFF
T4 rising edge OFF


Syncs strategy :
Sync cam count ON
Sync .MX OFF
Sync crank S count OFF
Nissan OFF


Magnetic / VR sensor sensitivity:
All set to 0


Sync setup:
Sync early ON
Crank sync skip OFF
Missing 0
.MX sync test 12
.MX time 0
Sync teeth 1
Sync error reset 11
Sync ignore 0


Crank tooth control table:
Set 0-11@ 5 12@3 & remaining 0

Injector phasing:
Injector phase 7
Injector tooth1 6
Injector tooth2 3
Injector tooth3 9
Injector tooth4 0


Ignition phasing:
Ign sync 0.43
Pickup delay comp 150
Ign tooth1 6
Ign tooth2 3
Ign tooth3 9
Ign tooth4 0


I have doubt my cam/crank edge trigger is not correct could u plz help me...

Regards...
Ali