Thread: TP to Data Scan

i am trying to add tp as a gauge function to my nds software and to turnerpro but i do not know where to find the "consult data register "in tunerpro

any help ?

Moved this to it's own thread... Are you OBD1 or 2?

I am OBD1 i think OBD 2 came already active
..but i found the xdf file with consult data registry enabled ...the other issue i am now having is, the xdf file i am currently using address is set at 1010 ,now when i use the xvi32 hex software the file i am working with consult data address is located at 7F50,when i change the address from 1010 to 7F50 alot of the registry addresses are empty (FFFF) which brings me to my next quest. should i copy all the registry addresses from 1010 hex location and paste to 7F50 location ?
hope i made sense

Keep in mind that 1010 is the beginning of the consult addresses, from the sounds of it you found a specific consult item. You will need to find where the table begins for your self

Check this thread out: How to: add TP streaming on B13/S13 etc ecus - SR20 Forum

my table begins at 7F50 ...and the tp stream for b13 is 4292 so i have edited the relevant info just waiting to test

Hey Vadim, I tried to do the same thing in my OBD2 ECU but at the time I opened the xdf at the notepad I couldn't find the line where I supposed to replace the address

Kevo did you try these instructions: http://www.sr20-forum.com/howtos/31809-how-datalog-tp-nissan-data-scan-b14s.html

I did but couldn't replace the text at the notepad, can't find the %%TABLE%% lines maybe I just have another kind of XDF

I think I have the xdf with consult registers already in it in the beginers guide to calum ecu tuning.

i also have it