Thread: nissan datascan + calum ?

bump can anyone help me with the drivers? i found nissan datascan 1.4 now i just need this cable to work. i haven't seen one laptop that still uses rs232! lol.

Hmmmm. I'm not sure but does this help?

USBSerialDrivers.com - Download FTDI and Prolific Drivers

or

USB to Serial Driver | USB RS232 Driver Downloads

i'ma have to try those thanks!

or you can manually put the car in timing mode if you like ...not very hard

nissandatascan gives you 4 licenses
you"ll need either the ob1 or obd2 consult cable and your consult port must be working in the vehicle. The common problem for guys who has done engine swap tend to have non working consult ports.
i can activate your nissan data scan software key ....i am a dealer for the caribbean
thanx

i have never been avle to get it into timing mode easy. so i'm allways paranoid that it isn't in time. i just want to finally be sure.

But i do have a better tune now. so maybe it will run better at idle so i can do it. when doing the "raindance" the car's idle is always high as hell!

rev it pass 3k a couple times then adjust the idle but above all make sure the car is at operating temperature

well i got it into timing mode via the cable i had kept trying different things till it worked. but i couldn't use nissan datascan. i changed the com port and now everytime i download it it says invalid com port. and won't open.

but i know the car is in time now via conzut. did find out that the maf is still reading a lil low if i put the idle at 750 or so making it rich so i put idle at 8-900 rpm. till i get a new maf.