Thread: 00-01 ecu pinout

hey everyone

not sure if this falls under tuning but i need a 2000-2001 b15 sentra ecu pinout, ive search in the fsm and found nothing. I might be looking in all the wrong places but if anyone has a pic of one or know what page its on it would help a lot

cheers


rob

Rob its in the fsm. usually found under the ecm or wiring diagram. I can look it up when I get back in town tonight.

Try looking again. EVERYTHING about the wiring is in there. Including the logic of what the wires used for, what to expect on each wire, EVERYTHING. It is pretty easy to skip over.

There is a spot towards the front of the section that has the pinout, followed by list and summary of wires, then it gets detailed, then goes into troubleshooting.

It has been several years since I've been through it so I am a little fuzzy on where exactly, but I know it is all there.

i just need to know the ignition check ( on the b14 pinout its # 2) i dont have it going anywhere, and the car ran for 3 years with ve motor and 1 year with a vet motor.

just wondering wat harm or what it wont let me do..

i kinda think nothing because it has not been connected before

cheers

rob

Hahah That one is special.

On RR Distributor only 1 pin on the 2 pin connector is used. The 2nd pin is that one. You have to run a wire to the engine bay for that one. There is nothing to splice into.

I can look into the logic of the signal, but I'd assume that if it didn't see anything it would retard the timing to safe guard the motor... but it could do nothing also.

BTW pinout for b15 start on ec-1496 ends on ec-1503

Sorry I forgot to look for this earlier.

its ok brother, my damn car is still down the shop just got it running with nistune type 4 board, so we see monday if any progress. he was having trouble telling the calum basic ecu what to do. so i went with a nistune

cheers

rob

for some reason my fsm didnt have all the pages... but i found it thanks

cheers

rob

No problem. Let me know if you have any other issues or questions. If you need a clean copy of fsm let me know.