Thread: jdm lowport swap problems

I just swapped a jdm low port in to my b13 and cant seem to get it to idle very well, or hold speed without bucking. i can put it to the floor and have no hesitation issues, but the tickets arnt worth it.

i swapped all the sensors, except the knock and maf. put the b13 dizzy and coil on what am i missing??

also when i unplug the maf the idle evens out ????
any help would be great, tring to get it ready for a car show.

Check the injectors. They might be sticking. Try banging on the housings while the car is running. It might help

what ecu are you running it with.are jdm low ports the same compression ratio?just curious on how you did the swap in regards if youre using jdm ecu with sensors or running your ser ecu

Stock b13 ecu , it's been done before with no problems ,

- - - Updated - - -

But I'm using all of my Ser sensors

are you running aacv iacv from your se-r?which im are you running.?no egr im assuming

are you running aacv iacv from your se-r?which im are you running.?no egr im assuming

- - - Updated - - -

are you running aacv iacv from your se-r?which im are you running.?no egr im assuming

sorry for triple post the laptop is acting up