Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Effing shift knob

+ Reply To Thread
Posts: 11-12 of 12
2012-01-14 12:26:19
#11
Wrap it with duct tape, then protect it with a towel or thick rag. Break it loose with a good sized pipe wrench.
2012-01-27 21:19:08
#12
Unfortunately I wanted to remove mine as well, but could not. I was just trying to replace the shift boot with a newer one with proper clips. I spent 10 minutes using all the force in my hands, then went to pliers, then realized it was starting to damage it. So in the end I had to cut the old one a little bit with a knife and pull it up and over the knob, and do the same to get the new one over it. Then I curled up the top of the boot fabric about 1/4" and put a zip tie under it, tight against the shifter bushing

Kinda ghetto, but worked
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top