Thread: 4 door xer questions

Ok so I bought a 93 sentra xe....body is nice and clean no rust and little dents....I have a 91 ser that I have been keeping to use for parts to.do a four door swap in. Now the 93 is a auto...have the pedals and clutch cable ran...and the motor is in along with the bay and engine harness. But when I went to hook up the dash harness some of the clips do not match up...such as the two for the doors...and one where the bay and dash harness connect...its long and blue...I believe that its for the automatic seat belts...and two others that I can't think of. So my question is...has anyone ran into this problem. Any suggestions????

try and get on sr20-forum.com The Dash. Most of the older guys from here are on there now. They can help you out.

i just did the same swap except i did a manual 94 i did not have to mess with any other harness except the engine harness everything else worked. did u change the accessory harness aswell?

Ya under the dash ..around the bay ...and engine

he is on The Dash...

Lol