Thread: Alfred.bin Needed - for N60 maf.

the bin I was running before yours didn't have cold start issues, if you want to see it pm me your email address, or just email me directly, [email]danny.wike@n2pub.com[/email] and I'll send it over to you and you can look at it and see if anything jumps out at you...

i don't have a wideband to check. unfornatly but it runs great.

same name as here @hotmail.com i'll give it a look over

Hey, I've been getting conflicting opinions about these bins... are they all looking for oxygen sensor feedback or are they open loop bins?

they should be lookin for o2 feedback

Can my wideband be wired into the ecu? Can anybody tell me how to check and see if it has been?

Thanks! Sorry to be such a newb!

uhhh some widebands can be made to run as a narrow band.. as for checking to see if its set to read o2 feed back there should be a feature somewhere to check it on an off.. in nistune its somewhere twords the bottom..

Hey, I've found a few other tunes/bins over the last week, but not sure how to post them... everyone but lynch's and this other one I found go lean when my N1's kick in... I can email them if somebody wants to post them....

the original calum N1
original frankie, and frankie with N1
pito
a supposed dyno tune (the other non-lean N1)...

these may be old to everyone, but I haven't seen them....

LMK

Anobody had problems with rich mixture with Alfred bin?

Stock SR20VE, SSAC 2.5", 2.25" exhaust, WAI

how rich is rich? it ran about 12.5 when i ran it.. i think that tiny exhaust might be whats causing it..