Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: NX2000 Awd Conversion

+ Reply To Thread
Posts: 351-360 of 361
2011-05-30 07:17:06
#351
Yea i bought the avenir
i bought the avenir Swaps going great sow far iam looking for a maf though and a down pipe if u know of one.
2011-12-04 20:05:15
#352
I knw I'm kinda late on this thread, but god damn! This is so sexy, I knw you have this done already, I've seen videos of it on Youtube. I was wondering if the back axles bolt right on to the NX's chasis? & what are the titles of the videos with the car running cause I can't find any like that? I have an NX2K aswell & I was gonna get rid of it cause I didn't have patients or money to start working on it, but I decided to keep him & I haven't regreded it ever since. I'm still working on it & now all I need is to repaint it Platnium Grey Mettallic, with Purple Rims & a polished on the deep dish rims.
2012-01-31 10:29:55
#353
im in the work right now and i didnt finish any because of this thread. i might be fired out from work tomorrow. lol

kudos to mr.threadstarter (businessman). he is not afraid of sharing his knowledge and experience with this swap.

now, here is my question. I saw a GTi-R front cut here in the local surplus shop and its just 1,800$, the cut is from the hood down to the shifter, evrything in the cut is there, ad22vf, tein coilovers, hood, engine, tranny, axle, dashboard. everything is intact. now the problem is running a AWD might not be possible, it is hard to find here the following:

-Gti-r drive shaft
-Gtir complete rear sub frame
-Gti-r gas tank

and i am just considering running in 2WD. is that possible?
my car is a LHD 4 door B13 with GA16DE in it.
2012-01-31 16:32:55
#354
you can run a fwd SR 20 trans and make it FWD.

axle and gas tank are hard to come but.

how's the dash on that car? i may need some piece from it.
2012-01-31 16:33:33
#355
Originally Posted by Gelo
I knw I'm kinda late on this thread, but god damn! This is so sexy, I knw you have this done already, I've seen videos of it on Youtube. I was wondering if the back axles bolt right on to the NX's chasis? & what are the titles of the videos with the car running cause I can't find any like that? I have an NX2K aswell & I was gonna get rid of it cause I didn't have patients or money to start working on it, but I decided to keep him & I haven't regreded it ever since. I'm still working on it & now all I need is to repaint it Platnium Grey Mettallic, with Purple Rims & a polished on the deep dish rims.


I used a complete rear subframe from a gti-r so no the rear axles will not bolt right onto the NX chassis but the front axles do.

You can find all of my videos at the following link. businessman244's Channel - YouTube

Originally Posted by datsun_sky
im in the work right now and i didnt finish any because of this thread. i might be fired out from work tomorrow. lol

kudos to mr.threadstarter (businessman). he is not afraid of sharing his knowledge and experience with this swap.

now, here is my question. I saw a GTi-R front cut here in the local surplus shop and its just 1,800$, the cut is from the hood down to the shifter, evrything in the cut is there, ad22vf, tein coilovers, hood, engine, tranny, axle, dashboard. everything is intact. now the problem is running a AWD might not be possible, it is hard to find here the following:

-Gti-r drive shaft
-Gtir complete rear sub frame
-Gti-r gas tank

and i am just considering running in 2WD. is that possible?
my car is a LHD 4 door B13 with GA16DE in it.


Depending on where you are located you can get parts from Canada which may be the cheapest way to get what you need. A fuel cell might be a cheaper route for a gas tank unless you can get your hands on a gti-r one. However most shipping companies are a bit picky when it comes to shipping used gas tanks. Also i'm sure you can get a 240 rear subframe to work if you shorten it to the correct wheel base. I believe the rear diff ratio of a 240 is ruffly .3 off from the gti-r rear diff but its been awhile since I looked into that.

If your considering running it 2wd with the awd tranny then I wouldn't recommend it. Yes, it is possible but you can't really beat on it with out the possibility of damaging the tranny. If you just accelerated normal then it wouldn't be so bad but I still wouldn't run it that way for a long time. You can always just slap on the fwd tranny and run it that way until you collect rest of the parts needed.
2012-02-01 10:20:20
#356
ouch that means i have to buy fwd lsd tranny with axle, unless the gtir axle can be use to fwd lsd tranny. it sucks cause i have to spend another 690usd. Yaiks
2012-02-01 17:16:17
#357
Originally Posted by datsun_sky
ouch that means i have to buy fwd lsd tranny with axle, unless the gtir axle can be use to fwd lsd tranny. it sucks cause i have to spend another 690usd. Yaiks


The awd & fwd axles are different so you won't be able to swap them between the two.
2012-02-02 00:09:15
#358
ouch... How about p11 axle to sr20/16 fwd?
2016-06-29 01:20:34
#359
Where is this car now?
2016-06-29 03:22:38
#360
Originally Posted by nissansr20nx
Where is this car now?


Heres what I know....Its gone to scrapheap.
That car was sold to a guy in VA who drove it from WA.Then he sold it due to rust and other chassis issues( I heard there was some handling issues that were never fully straightened out)
A guy with a B14 go the drivetrain and hes working on AWD 200sx
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top