Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: wiring in NLS

+ Reply To Thread
Posts: 1-10 of 10
2013-05-25 13:38:45
#1
wiring in NLS
how are you b14 guys wiring in the no lift shift? and where are the settings for it. all i see is min rpm, min tps and where the signal is coming from. there should be a timed section for how long the ing is cut, and a section on how the signal is interpreted(like b+ or ground, nc or no)

maybe its because im still on demo software (ecu hasnt showed yet)

Last edited by turbotank on 2013-05-25 at 13-41-42.
2013-05-25 14:30:51
#2
The ASCD clutch switch will need to be isolated from the ASCD system because it normally switches power. Then ground one side of the ASCD clutch switch and connect the other side to an available input (from the drop-down list). It's called full throttle shift (FTS) in NismotronicSA and is under the Limiters tab.

Dave
2013-05-25 14:39:48
#3
ok il just take the cruise wires and put them together iv never deactivated it by the clutch before anywho lol


but there are no settings for the NLS. there should be a place to put how many ms of ing cut to make it. on my srt4 i had it at like 180 ms for the shift
2013-05-25 14:49:47
#4
http://www.npcompleteperformance.com/_/rsrc/1347891683669/wotbox/software/wot_box_software.png?height=345&width=620

see the settings? thats the idea of the NLS is to cut the ing for a split sec so the trans slides right into the next gear like buddaa>>> simmilar to a air shifter on a bike
2013-05-25 14:59:34
#5
As currently implemented, there is no timer or ignition cut. The FTS rev limit (fuel cut) is active while the clutch switch is open.

Dave
2013-05-25 15:07:54
#6
Re: wiring in NLS
:grits teeth

Sent from my EVO using Tapatalk 2
2013-05-25 15:20:37
#7
Give it a try and see how it works. We're always open to implementing improvements.
2013-05-25 15:32:04
#8
Re: wiring in NLS
I would be open to addition of a timed thing . On my srt4 the nls by itself took off .7 on qt mile time

Sent from my EVO using Tapatalk 2
2013-05-25 21:13:24
#9
Originally Posted by turbotank
I would be open to addition of a timed thing . On my srt4 the nls by itself took off .7 on qt mile time

Sent from my EVO using Tapatalk 2


Give this a try and see how it works for you, if it isn't what you are after we can certainly add in the delay and maybe a strain gauge style setup.
Last edited by JKTUNING on 2013-05-25 at 21-17-32.
2013-05-25 22:31:52
#10
well i have it wired in. ill give it a try.. hey john did u get my email about the startup map?
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top