Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: B13 dizzy help

+ Reply To Thread
Posts: 1-3 of 3
2013-04-04 16:46:07
#1
B13 dizzy help
So I wired up a b13 dizzy, coil and igniter on my b14, the problem is that when I wired it I put on the b14 resistor on the power side of the coil, now I notice that the car wouldn't send spark so I pull the resistor off and the car started!! Now I was told that I need the resistor to get a tach signal now I don't have a tach on my car since it was a 1.6 to 2.0 swap.

My questions:

Do I need the risistor?
(If yes) what wires does it goes to?

Please I need help ASAP any help it input would be appreciated
2013-04-05 03:56:08
#2
Just going by memory, the wire is yellow or green. it might be different on an obd1 harness but i think its still yellow or green. i think its yellow before the resistor (on the harness side) then green after the resistor to the distributor.
2013-04-05 04:40:20
#3
Originally Posted by StangG20
Just going by memory, the wire is yellow or green. it might be different on an obd1 harness but i think its still yellow or green. i think its yellow before the resistor (on the harness side) then green after the resistor to the distributor.


Thank you sir
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top