Thread: Nx1600 in b13 e

Hey I have a b13e chassis and am making it ser. Wanted to throw the digital dash in for hoohas. Have everything wired up except the e never came with a tac. Does anyone know which wires on the nx1600 digital cluster are the tac I'm geussing the middle 9 pin connector the blue and black wire and solid blue. And where those will wire to?

heres a good place to start
http://www.sr20-forum.com/audio-electronics/53776-how-nx1600-digital-cluster-into-b13-se-r.html?highlight=nx1600

That my friend is exactly what I needed. I tried to find this but could only find the diagram not the pin layout. Have to use my phone this sucks

Keep in mind that you might find differences between the given schematics and your own clusters.

Yes I found that out but I'm still having an issue with the tach. In all of the write ups I've found they all say to use the blue wire from the ignition coil. I'm using an ser engine harness. And need to find out which ser ignition coil wire to use. Everything else works fine so far. Any help?

...glad to help.I hate that digital gauge setup though...haha

Honestly I like it. I rarely see and sentras and none of them have my interior or gauge cluster so it's uniquely satisfying. Plus I like that the Nissan digital cluster is like 70 bucks when Hondas is like a g note