Thread: Where to buy automotive grade wire for engine harness?

For those of you who wanted to see this happen, the pics start on post #1064 on my build thread and go on for a few posts after that.
I don't have the final total yet for how much actual loom and heat shrink (of each size) I used but I will have that for you soon enough.

For those of you who just want to see the damn harness as it sits right now, here you go. (The coil wiring and ground wiring still needs work.)

^^^ Looking nicee and clean!!

not trying to be cheap but what do you think about this kit?

eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices

Depends... What are you trying to accomplish?

Wow that llooks intense.

This won't be done to a dd, but it will do some minor autocross and drag.

I'm just wondering what you're trying to do. I assume by another post you made that you have an OEM harness you've de-loomed and you want to re-loom it.

Instead of asking you a bunch of questions, I'll say this. If you want to save TONS of time, get split loom (it is out there, and even in a mesh design if you prefer). And realize you're going to use some electrical tape. If that's what you want, don't buy that stuff.

If you're okay with trying to get this non-split loom over things, but still realize you're going to save a lot of time by using electrical tape, then by all means go ahead and buy that stuff. You'll be fine.

If you want to go the full monte and use the non-split loom and the damn heat shrink, then I would recommend finding something with a higher melting point (if that is even possible) to make the work with the heat gun less stressful and annoying.

You know, I need to read more. Didn't even realize it wasn't split loom! Lol

I'm only interested in putting braided loom on visible wires. What size loom would you guys recommend for injector, MAF and fan wires?

as small as possible for the amount of wires it will surround