Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Spec Clutch Installation

+ Reply To Thread
Posts: 1-2 of 2
2009-03-18 03:00:15
Spec Clutch Installation
Has anyone installed a Spec clutch on there Gti-r? I ordered one up and the bearing worked but the pressure plate does not fit. I can get two pins to line up and the third is a complete hole off. Clutch number is SN663H and my transmission is a 1990. Is there any chance they used different flywheels between the rally edition and road edition models? Thanks
2009-03-18 19:16:55
I talked to a couple forum members and the flywheels are the same. I also talked with paul from specs customer service department to solve the issue. Pressure plate is now on but it was a pain to install compared to others I've done.

You can see below how well the pins lined up with the holes. I had to hand start all the bolts then slowly tighten them evenly to get the pins to pop through and sit correctly.

+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top