Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Need help with clutch install: shifter is wrong position ?

+ Reply To Thread
Posts: 31-40 of 86
2017-04-24 20:28:39
Does it matter that this is a B15 trans
2017-04-24 20:36:43
Not to my knowledge..
2017-04-24 21:06:39
So there's only one bolt that goes inside the oval hole? The 98 Sentra SE FSM shows 2 in there. Stupid FSM.
2017-04-24 21:29:52
one long 14 missing in that picture he posted and one short 14 inside the oval that he also doesnt have. So yes there are two bolts
2017-04-24 21:42:08
That bracket has a total of 4 on a b13 see for sure
2017-04-24 23:27:56
Originally Posted by lynchfourtwenty
It goes in the hole, inside of the hole.. I know it's hard to get your ahead in there to see it..

Josh got it!

On a positive note, you will remember next time! That's how you learn.
2017-04-25 00:16:49
Just don't drop it!!!!! Trust me...I know.
2017-04-25 02:40:18
So the bolts are all in except that short 14mm. Still can't find it.

The shifter is in the correct position. I Drove it around the block, it shifts fine, but it sounds messed up. It shifts fine into gear but it has this rhymatic sound, almost like coming from the passenger side as your moving and you can feel it move around down below each time you hear the sound

Last edited by Storm88000 on 2017-04-25 at 02-42-37.
2017-04-25 02:45:29
Make sure the axle nuts are tight? What about the 3 12mm pass axle carrier bolts? Strut bolts are tight assuming u used that method rather than fucking up your ball joint?

That short 14 loves to fall an get stuck inside the hole.. best to find a new one an leave it for the next time the trans is out lol, unless you wanna take it all back apart..
2017-04-25 02:58:56
Axle nuts are tight, (just checked them again) and yep to remove the axles we undid the 2 strut bolts and those are tight.

Ok about the axle carrier - here's the thing- it only had 1 of the 3 12mm bolts in it from the previous owner. That's how I got it, and it was fine all this time (3 years). so I replaced the 1 bolt..
Last edited by Storm88000 on 2017-04-25 at 03-00-34.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top