Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Never ran into this issue...warm die

+ Reply To Thread
Posts: 1-3 of 3
2017-03-21 17:13:45
#1
Never ran into this issue...warm die
I was running my car to get it up to operating temperature to make sure I got all the air bubbles out of the system. Well the car was running for a good 5 minutes so and it just sputtered and died. I tried restarting it right away and the motor would just turn over and not fire.

I waited 5-10 minutes and tried starting again but this time it fired up and ran for another few minutes then died again.

Sorry for the amount of questions I normally figure this out on my own but this one was very odd and never came across this problem.
2017-03-21 17:26:21
#2
You went from highport to lowport, did you match CTS? (Coolant Temperature Sensor) to whatever harness you are using?
2017-03-21 17:54:18
#3
Originally Posted by Kyle
You went from highport to lowport, did you match CTS? (Coolant Temperature Sensor) to whatever harness you are using?


Yes. I used my highport temp sensor on the low port. It was working when the car died back in October. Possible it could have went foul sitting on the block for that long?


Edit:: Did I need to chance the spade plug next to the red temp sensor too? I am guessing it's just a ground.
Last edited by circa.13 on 2017-03-21 at 18-09-58.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top