Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: no spark

+ Reply To Thread
Posts: 1-8 of 8
2015-10-30 13:56:43
#1
no spark
if I cut my signal wire and jump it right to the battery with the key on I should get spark right?? cuz im not getting any at all. new coil, plugs, plug wires, and the dizzy worked before I took the motor out
2015-10-30 14:42:23
#2
Oh boy. You didn't do that did you? The signal to the coil is 5v. 12v could fry the coil driver. Special measuring devices are needed when you are getting into that level of diagnosis. However, you need to look at your fuses. There is a big ass one in the middle of the fuse box, the one under the hood next to the battery, that is the battery fuse. That one blew when I replaced my motor last, not sure why. Just did. Also, verify all your grounds are correct and you can find the troubleshooting procedures in the FSM at this site, How To Use NICOclub.com?s Factory Service Manual Database.
2015-10-30 14:45:54
#3
signal to starter not coil
2015-10-30 14:47:07
#4
im about to say fuck it and redo the wiring in the bay anyway
2015-10-30 14:53:34
#5
Signal to starter?
2015-10-30 14:55:59
#6
ya nvm the motors coming back out and im redoing the wiring and try to clean it up a bit
2015-10-30 15:02:30
#7
Pulling the motor to redo the wiring? Harness removal can be done with the engine still in. Takes an hour to pull the main harness.
2015-10-30 15:05:23
#8
I need to redo the other harness not the engine one
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top