Internal Trans HELP!
Hey guys, need a little help. I'm replacing my input shaft and gear stacks due to my input shaft bearing blowing up and damaging the seal which caused a severe gear oil leak and without me knowing about it, third gear went out. Anyways, as I was taking my trans apart I didn't have any intentions of replacing gear stacks so I could see what happened and what not so I didn't pay attention to small parts. Luckily I found the other small parts. I found my input shaft bearing balls all over inside and what not. Well, I need an answer about the 2 check ball springs. I found only 1 smaller ball compared to the input shaft bearing balls and found out where it goes. Well, I need to know if there is suppose to be another ball where the thinner longer spring goes. I figured the 1 small ball I found came from the hole where the thicker spring goes. Is there suppose to be 2 of those balls? Here is a pic of what I'm talking about. I circled the 2 springs and a question mark about if there is suppose to be another ball that goes in before the longer thinner spring.
PIC IS FROM a TSURUSER post
[img][URL=http://s1242.photobucket.com/user/mikeamy1214/media/internaltrans.jpg.html][IMG]http://i1242.photobucket.com/albums/gg529/mikeamy1214/internaltrans.jpg[/img][/URL][/IMG]
PIC IS FROM a TSURUSER post
[img][URL=http://s1242.photobucket.com/user/mikeamy1214/media/internaltrans.jpg.html][IMG]http://i1242.photobucket.com/albums/gg529/mikeamy1214/internaltrans.jpg[/img][/URL][/IMG]
Last edited by sr20fan
on 2013-07-11
at 18-10-09.