Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: B13 e- b13 ser

+ Reply To Thread
Posts: 1-8 of 8
2012-09-03 00:33:54
#1
B13 e- b13 ser
Making a b13 e into a turbo ser. Can't seem to start the car tho. Car will sart if I jump the starter to the battery but not by key. I replaced both bay harnesses with the ser. And dash will light up but not starter. Any suggestions?
2012-09-03 00:38:35
#2
Do you have all your grounds in place?
2012-09-03 01:38:25
#3
Will it crank at all? If not,see if the little rubber plug fell off the clutch pedal.It's what hits the switch below the pedal,and they tend to fall off.
2012-09-03 01:58:25
#4
^ Yeah it's prob the clutch inbt switch. Bypass and try again
2012-09-03 16:15:18
#5
No I just tried this. Clutch switch not the issue. I have power to the starter but no signal.
2012-09-03 22:41:29
#6
Ohm the wire in section then. Did you try to wire tuck ?
2012-09-12 20:46:28
#7
no i have not tried to perform a wire tuck. does anyone know what components/ wires are in the ignition cercuit ill do a search as well. anyone have any ideas other than the previously stated
2012-10-25 12:33:56
#8
Found out that I seemed to have lost the plug connected that goes from the driver side harness to the starter. Made my own harness. Works fine. Went back to n/a car seems to run perfectly fine now.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top