Thread: does anyone make crossmember bushings

instead of stockers, does anyone make any urethane, plastic(delrin), or solid aluminum bushings for a b14? im talking about the 4 (2in back 2 in front) bushings between the crossmember and sub frame/core support that run front to back in the middle of the car.

thanks

http://www.sr20-forum.com/suspension-brakes/43462-ca-fs-p11-p10-b13-b14-b15-crossmember-aluminum-delrin-bushing-combo.html

There you go!

I have a set, very well made.

thanks guys ...orderd

Those look great, a little out of budget for me right now. I was at Ace Hardware and they have fairly large Nylon spacers that if the center was drilled out would be perfect for this. Those are only a couple bucks each, not as stable but a possible budget friendly option vs stock rubber. Not sure if I can use both the stock rubber and some nylon inserts, that would be better than stock. If it works i'll post some pics.

Sorta like this for $10?

^Yeah pretty much.

Great minds think alike!

Those extra's btw?

Sorry, no extras. Contact [email]rob_silvester@hotmail.com[/email] and ask him about his "wheel hop aids."

He has 2 different types, 1/2" thick and 1/4" thick. I purchased the 1/4" thick on put 1 on each side of the crossmember. Or, you can do the 1/2" thick and put it one side.

Although these were only tested on b15 sentras...I'm not sure of the difference in xmember bolts for b13/b14.

Just sent him an email. Thanks for the referral.

Your set looks much more polished then mine did. I installed Maxima bushings, they needed some fitting, they do move a bit more, but you don't feel the vibrations into the cabin as much as you do with Rob's bushings.

http://www.sr20-forum.com/751543-post1268.html