Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: B13 variable intermittent wiper mod? YES!

+ Reply To Thread
Posts: 41-50 of 103
2012-04-03 05:29:21
#41
Originally Posted by SE-RMonkey
There are four screws that hold it into the body. Remove them, lift the board, snap a couple pics and put it back together... but only if you're comfortable doing it.


No problemo bud. So you can diagnose the board right? If I manage to be early home. i will do that today.
2012-04-03 12:11:10
#42
Originally Posted by datsun_sky
.... So you can diagnose the board right? ....


Yes, Sir!

I am most interested to see the backside of the area I have circled in red below. This is where the "volume" traces lead to a series of components and where I believe the difference(s) between the PHDM and USDM boards lie.

2012-04-03 17:19:19
#43
Originally Posted by M0J0
Lol, why did Nissan give the cupholders to USDM NXs, and not to the EDM ones? Why did your NXs get crappier headlights than ours?

Who knows?

Better factory brakes in the USDM B13 NX2000 vs USDM B13 SE-R.

Better factory seating in the USDM B13 SE-R vs USDM B13 NX2000.

Did creating/engineering two (2) sets of brakes and two (2) sets of seats, for the same damn USDM B13 chassis, really save Nissan any money? ....

I like the idea of intermittent wipers on my Classic. Not that is sees much rain anymore.

Go SE-Rmonkey! Reverse engineer this Hoe-EM upgrade.
2012-04-03 18:46:12
#44
Just to add to this, this is only for non-airbag B13's as well...
2012-04-03 19:00:45
#45
Originally Posted by SENTRASER
Just to add to this, this is only for non-airbag B13's as well...


Good point.
2012-04-04 00:03:37
#46
Originally Posted by Shawn
....I like the idea of intermittent wipers on my Classic. Not that is sees much rain anymore.

Go SE-Rmonkey! Reverse engineer this Hoe-EM upgrade.


If/when I figure this out the XE will get the mod. The SE-R doesn't go out in the rain and must remain as unmodified as possible.
2012-04-04 01:03:17
#47
Bro arrived home late but still i tried to pull that board out.


But I failed. I removed the screws first and....
When I am trying to pull it out by inserting a knife but I am scared to broke the board. I guess i should take a lot of guts first. lol
2012-04-04 01:42:56
#48
With the screws removed that board should fall right out, no prying! As I see in the pics there is already one screw out at the white connector. The three remaining I have circled....

2012-04-04 06:06:40
#49
Damn me!!!! I didnt notice that!!!! I 'll try that again later
2012-04-05 18:18:05
#50
bud, the long wait is over.
I guess this is what makes the intermittent wiper runs

the box labeled "Taiko". i think is an IC, under this is the 2 wires welded that goes to the switch, what do you think bro?
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top