Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Sanding or Milling?

+ Reply To Thread
Posts: 1-3 of 3
2011-11-19 14:26:54
Sanding or Milling?
Just curious what everyone's thoughts are on sanding or milling a cylinder head. This topic has come up a lot lately at the shop and curious to know some pro's and con's.
2011-11-19 14:35:03
Should be ok if done correctly. It just raises your compression.
2011-11-19 15:04:00
I would think a mill would be more precise, but if a sander could be setup in the same manner, it may provide the same precision. However, I would think you go through belts fairly quickly. Especially if using a finer grit for a smoother surface. You would almost have to change belts a few times, where a mill would do it one pass.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top