Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: JWT ECU Info

+ Reply To Thread
Posts: 11-11 of 11
2011-08-30 22:04:19
page 11 is what u are interested in, rest of it is good reading too. It seems the B14 ECU requires moving 2 jumpers.


Calum has this information so it could be that the AUDM and JDM ecus are diff from the USDM, in any case a comparison with the JWT ecu and the new one will clarify things

"B14 Board Instructions

Install Ribbon cable in top most row of 40x1 holes on the ECU (marked W001). Move jumper (0 Ohm resistor) at R025 to R022, as shown below."
Last edited by yoshoto on 2011-08-30 at 22-32-40.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top