page 11 is what u are interested in, rest of it is good reading too. It seems the B14 ECU requires moving 2 jumpers.
http://nistune.com/docs/NIStune_Type_4_Hardware_Installation.pdf
Calum has this information so it could be that the AUDM and JDM ecus are diff from the USDM, in any case a comparison with the JWT ecu and the new one will clarify things
"B14 Board Instructions
Install Ribbon cable in top most row of 40x1 holes on the ECU (marked W001). Move jumper (0 Ohm resistor) at R025 to R022, as shown below."
http://nistune.com/docs/NIStune_Type_4_Hardware_Installation.pdf
Calum has this information so it could be that the AUDM and JDM ecus are diff from the USDM, in any case a comparison with the JWT ecu and the new one will clarify things
"B14 Board Instructions
Install Ribbon cable in top most row of 40x1 holes on the ECU (marked W001). Move jumper (0 Ohm resistor) at R025 to R022, as shown below."
Last edited by yoshoto
on 2011-08-30
at 22-32-40.
Be the first to like this post.
Back to top
