Thread: when getting machine work

then you may have to send your block off somewhere. Ask veilslide180sx where he got his block done. Its local and I know he only had a small overbore done but I know he did it right.

i dont know the guy man. maybe you can find out for me? hehe

It doesn't matter if you know him. He's really cool. I'll hit him up this week and see what he says.

appreciate it!

ok so i was lookin around online and found a place that uses a tq plate when they do their machine work and they have done sr20's before.. heres a link, their in CT so maybe you some of ya know them? Custom Design Performance - Main Index

they charge 250 for machine work and they will assemble it for 350 so thats not bad really..

should i just do freakin n1 pistons or turbo it or what?

I was wondering about that place^^^only place I could find on the interwebs that had a torque plate....
Intersting link, shows a VE in the LOWER LH corner of the web page.
http://cdpautomachine.com/ecatalog/importengines.html

and a couple highport de's and a vr6. the ct guys say this is a good shop to use.

and subi ej motors those aren't easy motors to build either.