Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: JDM power folding mirrors and using a relay to open and close them

+ Reply To Thread
Posts: 11-11 of 11
2011-06-11 12:12:37
#11
Well test it out if you can to see if that resettable fuse stays tripped with your switch in the fold or unfold position and not returned back to the neutral or if it goes back to trying to supply power after every couple seconds or so. If it does then you will definitely need some sort of box that controls it. Shouldnt be too hard to find. What would make sense would be a tripped switch circuit with a one way diode on a bypass. So when its tripped it stays cut out until power is ran through the other way. This could be controlled by by using one way diodes on each side of the circuit. If only the mirrors were that way. Basicly with a contact switch built in on both sides.

If you could find out about that info that would be great.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top