Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: engine doesn't start after installing a distributor and a clutch kit.

+ Reply To Thread
Posts: 1-8 of 8
2010-06-06 19:51:23
#1
engine doesn't start after installing a distributor and a clutch kit.
I replaced my clutch kit, when I was installed the flywheel. I rotate the crank like 1-2 inch.
I put a mark guide because when I put the flywheel or Pressure plate, The crank rotates, then I can rotate to the original position according to the marks.
But I forgot to accommodate according to the marks and I put back the transmission.
Before that, I removed the distributor , I don't remember why.
supposedly there is a only way to put the distributor, but I don't know.
I already install the distributor but the engine doesn't start. Only cranks and makes funny noise but doesn't start.
2010-06-06 20:27:20
#2
YouTube - engine doesn't start
2010-06-06 20:33:11
#3
Try rotating the distributor,
2010-06-06 21:12:57
#4
firing order?
2010-06-06 21:51:56
#5
firing order is prob off or the distributor is bad
2010-06-06 22:33:00
#6
It sounds funny. Does it have fuel? Does it have spark?
2010-06-06 22:43:41
#7
Fixed, I replaced the rotor and cap, and the engine starts
2010-06-06 22:44:11
#8
tHanks to everyone
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top