Thread: engine wobble when I let out the clutch pedal...

+ Reply To Thread

First

Posts: 11-14 of 14

Search Thread

2010-05-21 05:06:27

#11

mrbass

Member

Join Date: 2007-12-16
Location:
Posts: 159
Trader Score: 0 (0%)

I didn't yet resurfaced the flywheel , because the alternator and distributor failed in the same time, and I'm working for money to replace them.
But before that, I checked the transmission mounts and there isn't nothing wrong.
A missing bolt, but I never had that bolt.

0 Likes

Be the first to like this post.

Reply Reply With Quote

2010-05-21 16:24:21

#12

ianh

Not a newbie !!

Join Date: 2008-07-08
Location: Richardson TX
Posts: 143
Trader Score: 0 (0%)

Originally Posted by 92SentraSE-R

I disagree... Last time i changed my clutch, I didn't resurface the flywheel, it was in good condition, no groves or anything. Well... After about 2 week's of driving it it started the wobble when taking off... Felt like the tires were skipping or something.. Flywheel was resurfaced, problem was fixed...

Well i am just replacing the clutch on a 3.0 and didn't re-surface. Will let you know if I have an issue. ( I did clean the surface with 400 grit and then clean it well, all by hand.)

0 Likes

Be the first to like this post.

1997 200SX SE-R Manual. gone to the wrecker yard in the sky !!
2003 Pathfinder SE 4WD
Ex- 2001 Sunny N16 RHD (N16 Nissan Bluebird Sylphy)
1997 Sentra GXE w/195/50 15's and AD22VF, Tach, Halo's, Front seal, Rear SER Disc Brakes Sold !!

Reply Reply With Quote

2010-05-21 16:33:12

#13

ianh

Not a newbie !!

Join Date: 2008-07-08
Location: Richardson TX
Posts: 143
Trader Score: 0 (0%)

BTW i did replace a clutch center disc once as a precaution, came apart for final drive problem, and didn't replace the pressure plate.
Bad decision, the belleville type spring gets weak over time, and doesn't provide the clamping force. Clutch ended up slipping.
I also replaced my Sentra clutch for slipping, was bad from 50k to 85k till I finally took it down, center plate was fine, had enough lining for another 50k !!!

So replace your pressure plate even if it inspects good unless you can check the clamping force spec ( I cant !!!)

0 Likes

Be the first to like this post.