Thread: Alarm wont let it start... HELP!!!

i drove the car all day today and i have an aftermarket alarm in the car... i went to start it tonight and the car all o a sudden set off the factory alarm... i dont have the fob for it. when i bought the car(this past week) i was never given one. and now the car will not start the factory alarm has disengaged the ignition cylinder and it wont let me start the car. please guys any ideas???? im desperate i want both alarms taken out but i also want t be able to start my car.
thanks

i have the aftermarket fob but not the stock one. i just need the car to start and i dont want it to lock the ignition cylinder....

there is alot of intimidating wires underneath.

the factory alarm is disabled when you unlock either door with the key

If your alarm is acting up and you want to remove it anyway, try removing the fuse holder ''under the dash'' also follow cabling from alarm to the cables under the carpet drivers side.

There should be atleast one wire cut (behinde the fuse holder are 2 big Nissan connectors, probably there) this cut wire is routed in the alarm and back. Try reconnecting this wire. If car is ok again, cut out the alarm. This worked on a B13.

Btw, if there is cable mess, try first removing sensor cables, don't start cutting on good faith, might end you up with a non starting car and no good lead to follow.

if you remove the door panel, the alarm wire that disengages the alarm systems comes from the lock cylinder, and is green. Simply ground this wire constantly, and the system will never arm.