Thread: Can anyone tell me about this strut bar?

I'm trying to find this strut bar, but I'm not sure what it's off of. Is it a pulsar or the b13 strut bar Cusco makes? Anyone happen to have a part number for it?
Or is this it Cusco Strut Bar OS Front B13 200SX

Look for the one that fits the Pulsar. I think the chassis code is RN13 or 14 or something like that

Or the one in the link also works. They make 2 or 3 different styles of strut bars for our cars.

this is off of a 200sx, and here's the info courtesy b14 se-rious on the other forum.
"Cusco front and Tein Rear strut mounts"

the b13 bar is all pc blue with an adjusting bolt int he middle.

here's the link - that's his exact car.
1995 200sx se-r COMPLETE PART OUT TONS OF GOODS, cams, koyo, coilvovers, etc - SR20 Forum

Pulsar GTiR is RNN14
Pulsar GTi is N14

Both are same as B13 chassis, strut braces fit.

so the one in the link is this bar or no?

cusco - check. If you look close it says so on the bar
b13/200sx application in your link - check. as I showed in my link
bolt on the tower side instead of the middle - check. the happynole gb b13 cusco fstb's are blue pc on the whole bar.

I'd bet my firstborn this is the same bar.
Closer photo of it - even the triangle lip is the same

I got the pic from that thread man haha I know it fits our cars, I'm just trying to make sure that's the one. I don't like the other cusco bar so I been trying to find this, i thought they didn't make anymore until I found that last night.

I know this is an old thread but just had a question... This is the bar for rnn13/14? At first when I found this bar I thought knock off. I only knew of the other bar. Now I'm souped that it's a real bar I'm assuming just not a design released for the b13/14 even though it's the same thing.

The bar is for the JN15 VZ-R with SR16VE i'm pretty sure (which is basically a B14 chassis). The RNN14 cusco bar goes back towards the firewall to clear the quad throttle plenum.

EDIT: Just found a Pic of the VZ-R brace fitted, and its a little bit different to the one pictured in the first post. Specifically the mounts where they bolt onto the towers is different and it seems to peak/sit a bit higher, so i guess i wasnt right. Sorry.