Thread: Import Newbie Need help..

im suprised you found 1, i've seen some g20s but never an se-r in the yard.. lol

grab the tranny, axles, radiator, wiring harness ect.. btw is your car already a manual? if not grab the clutch / brake pedal stuff, shifter bars an shifter, also the cross member an brackets, grab all motor mount stuff for back up, or "just incase"

other things to think about is the rear disc brakes and suspension, i'd grab the sway bar, lower control arms and hubs an calipers.. grab the front calipers too an hell i'd grab the struts an springs too! i got all 4 for 80 bux one time..

its not often u find a se-r in the junk yard.. even if u didnt use the parts i mentioned u could easily sell them to someone who wanted to do a full conversion..

also think about grabin the seats.. soo much better then the others..
oh an grab the trunk!!! hehe

anyway theres my .02 buddy.. have fun!

buy the car take what you need and then scrap or sell the other stuff. Not to be a dick but if this is your first time with these cars and you dont have somebody helping you this is going to be very challenging for you.

Also you dont need a book just look in the driver side door jam it tells you everything on the sticker.

If anyone can show me a 94 b13 with a lowport from the factory I will be very suprised.

all the local junkyards around here wont sell the whole car.. only parts from it..

that sucks I never tried but I know some like rent them out and you take what you want and then they come pick it back up for a flate rate.

well over here in southern cali there alot of yard the one i found this one at is very big and busy yard havent gone back but the car usually last a week or two before they remove them man they had already took the doors hood driver side fendar that i needed and well the back there nothing good the car got rear ended although the brakes might be good well tommorows ima have time in the morning to go pull out the motor and trans....

jesus christ. did you graduate elementary school? it amazes me the kind of people into these cars nowadays... if you don't have the proper education to use proper punctuation, how can you build a car?

anyways welcome to the forum. which area of southern california are you from?

thanks for welcoming me asswipe, my ****ing iphone is not fat finger friendly if u know what i mean.. small touch screen and big fingers dont go together very well..oh this ****ing car is just a toy ive never tought of building one of these little fugly things, but tought it would be a great car to hustle people with since everyone know adays thinks racing a v8 rwd is cheating lol it aint my fault they preffered to build a ****ing 4cyl fwd as a drag car ..i mean who those...lmao...well anyways this car is getting build just for **** and giggles and yes a couple of buddys of mines are helping me they actually work at a shop up here in gardena they specialized in skylines,supras,sc300,240,rx7,1jz's,2jz's sr20's rb's u name it they can tuned it they even have a in house dyno so if any of u guys need tunning or dynoing...hit them up his name is STEVE ROGERS AT SR MOTORSPORTS they are located in gardena ,ca in the corner of MAIN AND GARDENA BLVB.......

So what exactly do you need our help for again?

well hopefully your fat fingers aren't attached to fat hands - because working on an import is slightly tighter spacing than most v8's I've seen...good luck with your build!