Thread: My 5 lug P11 99 G20t

If you dont want a ABS light and you want your ABS to still work then yes it matters.

For me I have to go take a trip to a local machine shop (well not so local). I have my stock P11 rear hubs with the sensor rings on them still and I also have a spare set of rear 5 lug hubs, Im gonna pulled the ABS sensor ring of my stock P11 rear 4 lug hubs and have them opened up (machined larger) and then pressed onto the the new rear 5 lug hubs and problem solved.

Roughly about 4-5mm the I.D. of the stock rear ABS sensor ring has to be opened up to fit onto the rear 5 lug hubs.

If you attemped to remove the ABS sensor ring from yoru stock 4 lug hubs make sure to use a 4 jaw puller maybe even a 3 jaw will work but do not use a 2 jaw because you will distort the sensor ring.

I haven't really looked into the abs rings before. I figured you could use sensor from P11 on the B16 ring and it would work out, guess not.

Brent

looks nice. but whats the purpose?

Better rim selection and I already had the G35 wheels and wanted to put them to good use.

Yup, way better rim selection, and room for BABK!

B16 use completely different hubs as the balljoint is a throughbolt and post setup and i am not sure the axles will work looking at the specs on timken.com for the hub assy. as opposed to b13/14 wheel bearings which are press in as opposed to bolt in like B16 and the b15 still uses the press in bearing type but a smaller bearing bore than previous models. Altima 93-02 uses same bearing but 4 lug 5lug altys use different bearings. i did this to my B13 with redrilled altima spindles but will use 3rd gen maxima (89-94) to make it factory like.

Just finished my P10 conversion front and rear, ass of a job and not cheap either

If anyone needs spacers for the rear P11 5 lug conversion just pm me I can provide you with them, heres a picture.



Looks good P10

Heres an update of my P11 with TEIN SS coilovers now

So the front hubs are bolt on and rears need the spacer and machine work ?
How much you asking for the spacer.