i always use a nissport oil dist block for the oil feed coming off the oil filter housing.
then i do a 1/8" npt to -4an
then i make my an hose to whatever length i want
if turbo is ball bearing with -4 run a restrictor
or -3 an hose
with the drain i would run a -10 an hose
i use a 3/8npt on block to -10an fitting
ATP offers all these things to setup just about any turbo or setup
they sell premade hose for feed and drain
or you can piece together
Autometer has some good feed hoses that they sell for gauges but u can use for turbo feed
then i do a 1/8" npt to -4an
then i make my an hose to whatever length i want
if turbo is ball bearing with -4 run a restrictor
or -3 an hose
with the drain i would run a -10 an hose
i use a 3/8npt on block to -10an fitting
ATP offers all these things to setup just about any turbo or setup
they sell premade hose for feed and drain
or you can piece together
Autometer has some good feed hoses that they sell for gauges but u can use for turbo feed
Last edited by Doug Fab
on 2013-08-24
at 01-26-39.