Thread: b14 part out orlando area

Hi everyone...well i totaled my car so its now sitting in my garage ready to be parted out. i just swapped a new high port motor in there with a new 5th gear in the tranny as well. if anyone needs anything just pm me and ill pm back if the part is alright along with a pic of it.

for sure i know my two front seats are in perfect condition and the dash and motor..i also have a super autobach ftsb and i have a rear but unknown condition due to the fact that i havent been able to open my trunk yet since its crushed in lol so just let me know what u guys want..

also have an ebay header and still in awsome condition and a new bumper with a stillen lip bolted and primered ready for paint...the lip came off place from the bumper a little but i popped it back in..i would suggest to re-touch on it a little bit.

What year is the car?
How much for the Stillen lip. Let me know the condition on the Sunvisors, the drivers side window regulator and power window motor. Do you have the stock floor mats? If so How much. What exhaust do you have?

PM sent.

I am intresred in

1. Axles Right and Left
2. Radiator
3. ECU 95-97 SER
4. Wireharness 95-97 SER

Front Bumper

lip has to go with the bumper since i kinda bolted and glued it to the new bumper lol so ill give that up for 100 obo and the sunvisors have always been sh*t so dont even bother with those and the power window motors worked great but havent tried them since the accident since my battery is dead...and yes i have ALLL the stock floor mats in PERFECT condition...drivers on could be considered a little worn on the heal part of the throttle side

exhaust tip was bent in half but the rest of the pipping is unkown at the moment on the condition but its a whole two and a half inch from cat to back

Damn. Exhaust piping might have a leak then.

But yeah. Ill buy the power window motor and regulator. Ill also buy the stock floor mats.

Ill send you a PM in about 10 mins.

I wont get the bumper. I just wanted the lip.

pmed

please pmme a price for the header and what size is it???