Thread: Building a Transmission Gear Cuff for the P11 2000-2002

I'm always ready....

Any updates?

WTF! I cant beleive I wasnt aware this was in production. I just bought a 70v box from dave too. mos def intrested.

I think enough peer pressure he will start building these for us

LOL Thanks for the support. It's installed on my trans. I just need to dyno tune and race the car to make sure it does what it's supposed do.

Measuring center to center on the bearing fits on the case will get you that.

I ended up doing this. My first measurement was a rookie mistake measuring the stacks free standing in the bell housing with my hands holding the stacks together. 0.50mm was what I was off

Bumping this back. Carlos has one in his NX and Mike has one in his P10. Mike already drove on it with no issues. Just waiting on the drag results

Any updates on this?

Anyone though about caging the transmission as well? Try to get as much reliable power through one of these transmissions, of coarse with every other addition you can do like freezing and peenin' !