Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Transmission removal

+ Reply To Thread
Posts: 21-24 of 24
2014-01-14 08:21:59
Originally Posted by lynchfourtwenty
Originally Posted by 92SentraSE-R
Originally Posted by lynchfourtwenty

#1 dont stick shit through the trans to beat on the axle, it dont work.. ask me how i know..

lol i know this was a while back but just wanted to make sure I say, BS to that lol

No bs sir.

If you look up at the link I posted I did just that and it worked 100% where all other methods (other than sledge hammer) failed
2014-01-14 11:17:58
Your both wrong. Always follow the FSM it clearly states to use a Griffendor Wizard Wand with an axle removal spell. Fing amitures!
2014-01-14 12:24:31
I normally leave that axle in. I just pull the tranny out and let it down, it clears fine.
That's using a lift. On the ground it would be more difficult to do.
Going back on I slide the tranny on the axle first then the input shaft into the clutch next.
Last edited by kevwal on 2014-01-14 at 12-26-17.
2014-01-18 01:31:14
For future reference, I've found that if you turn it a little bit at a time and give it a little yank each time the stubborn ones eventually come out. Same going back in.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top