Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Thread size/pitch question

+ Reply To Thread
Posts: 11-11 of 11
2018-03-21 10:26:06
Originally Posted by SE-Rtainlyb13
The tricky thing is getting a structural stud that is a class 10.9 (roughly SAE Grade 8) that had threads long enough. Everything I’ve seen online has partial threads or the stud itself is too short unless you get it from China with a minimum order of like 5000 pieces. The stronger the stud the shorter it is. One thought I had was buying extended wheel studs and cutting the knurled end off to make a fully threaded body, but they are all too short unless you change the thread pitch. Wildmane, if you don’t have extra studs lying around I may opt to buy a stud with a more common thread since I’m doing my own tapping anyway. Even then, it is difficult to find the correct length but it’s more feasible.

Hey I haven't been on the forums but I'll look around today for them. I'll see what grade they are too.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top