Thread: Interest in bumpsteer Eliminators?

We might be doing a limited run of bumpsteer eliminators depending on interest and pricing. We are in the process if getting things quoted for final pricing but we should be in the $150 range per set. These would fit the B14 & B13 and can be made to fit the P10 by using the B13 inner tie rods. Not sure about the P11 but i assume the same is true.

Similar to these.
http://www.sr20-forum.com/bolt-bars/30241-bumpsteer-kit.html

Post if you are interested in a set.

I am more interested in what it will be made of and how you will accomplish this.

I have only driven ~2400 miles in the P10 and had zero to very little bump steer as stock. Unless the difference in how much you lowered your car vs mine is that extreme to cause bumpsteer.

It is mainly for the B13/B14 but can be made to fit the P10 as stated. You may not need them in your P10. They will be similar to the Octotat version.

I never drove my P10 with out them so I do not know if they are any better than the factory tie rod ends or not for the P10. I know the B13/B14 can benefit.

Aren't you at -1.5 degrees camber?

OEM is plus or Minus ~ 0.5 degrees camber

- Camber is gained via suspension compression / wheel turning (when talking about the front multi-link suspension that many folks dislike here)