Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: About to cut out a Mazworx Chromoly Roll cage...

+ Reply To Thread
Posts: 1-6 of 6
2014-03-02 15:29:40
#1
About to cut out a Mazworx Chromoly Roll cage...
In Central Florida. Out of an Nx2K. Wanted to know how to cut it out and if anyone is interested in it. I believe it's a 5 or 6 point. Thanks

How to cut it out as in where I should make my cuts.

Mike
2014-03-02 18:21:25
#2
I'd get it if you were local. No idea where to cut though.
2014-03-02 22:43:16
#3
Try to make the cuts as close to the ends of the pipes were they join together. Don't cut pipes in the middle. Even after re-welding them they will be week and garbage.
2014-03-03 01:11:55
#4
So it ended up being a 4 point and other than the factory welds(beautiful) the U-welds were weaksauce and sputtery looking. If I have the time, and a cordless Sawzall I may go back. Thanks guys.
2014-03-03 01:55:49
#5
4 point cages are cheap so it might nt be worth the work. If you do take it on cut it at the point that meet the body and then the weld points to remove it. Don't cut the full hoop if it has one.
2014-03-03 02:09:52
#6
Forgot to take a pic. It's in good shape with no rust, olive drab, still has the logo intact. It may be worth 2 sawblades but not 3
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top