Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Shig speed rear mounts and GC camber plate q?

+ Reply To Thread
Posts: 1-5 of 5
2010-10-22 00:13:46
#1
Shig speed rear mounts and GC camber plate q?


does this look wrong? i found a picture on some ones install showing the block piece under the mount instead of on top like the ones i have. any idea what way is right or better?
2nd
i have a set of ground control camber/caster plates that are paired with koni yellow inserts. the nut that attached the plate to the strut on one is wearing and i would like to replace it but i am not sure where to get it. there also seems to be some spacers used here and there bending so i will need to replace them but cannot find part numbers for them. i know there is a thread with them but i cannot seem to find it.
2010-10-23 00:05:04
#2
That bolts up through the body. Directly under that you should place a 1/4" thick urethane bushing, and butted up to that the aluminum tophat (with the bore matched to the strut shaft). The stepped nut: You can use an ET-open end lugnut. Most tire shops can get them for you. It's going to probably be a M12x1.25 or possibly a M12x1.5.

Good luck!

_SHig
2010-10-23 00:26:45
#3
ok thanks. i just wanted to make sure i had assembled the mount correct i have only seen 2 pics of this mount and one has the metal block under the plate and one on top,
SHigSpeed Install
that is a link to the pics where the mount looks oposite of mine.
2010-10-23 03:20:43
#4
Ah, that's a B14 install.

_SHig
2010-10-23 14:16:17
#5
sent you a pm with couple of side questions
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top