Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Justin's budget all motor/OEM+ build

+ Reply To Thread
Posts: 1-10 of 51
2014-10-27 00:31:50
#1
Justin's budget all motor/OEM+ build
Here's everything I have going in so far, feel free to offer any suggestions for parts or tuning or anything you feel necessary

Block:
-cleaned/decked/honed
-Stock rods with ARP bolts
-VE pistons with new OEM VE rings
-ACL race crank and rod bearings

Head:
-rebuilt with new valve guides and seals and decked for straightness
-ARP head studs
-Stock lowport cams

Ignition:
-NGK plugs
-Stock wires

Fuel:
-VE fuel rail and injectors
-off brand afpr

Intake:
-3" piping
-N60 MAF
-3" velocity stack
-6" filter

Other:
-Unorthodox racing crank pulley
-JGY 8.5lb flywheel
-Exedy stage 3 pressure plate
-JWT clutch disc
-new OEM throw out bearing and clips

Also running a stock header unless someone wants to sell me one unless @jet gets his header off his car first..lol

Hope to have some fun with this until I move on to my VE beast build
Last edited by justin2386 on 2014-11-19 at 13-38-47. Reason: edited parts list
2014-10-27 02:35:47
#2
why ve pistons?
2014-10-27 02:37:28
#3
Because the motor I bought had a messed up piston and I got a good deal on a set of VE's..and for the little bit of a bump to the compression ratio
2014-10-27 13:44:43
#4
Nice build man, i'll be tuning in for future updates!
2014-11-05 21:21:17
#5
Looking forward to seeing this! Good luck!
2014-11-08 19:49:11
#6
Motor is almost all the way back together! Just have to button up oil pans and then the blown motor can come out of the car and everything will be swapped in!
2014-11-08 19:52:26
#7
What are people's suggestions for a MAF? I was looking around for a MAF sensor info thread but couldn't find one anywhere
2014-11-10 13:53:43
#8
I would go N60 and go with 3" intake
2014-11-10 14:05:16
#9
Does anyone make a 3" intake? Or am I better off say hacking up some intercooler piping or something like that?
2014-11-10 14:16:42
#10
I used a universal kit from ebay, it needed a little modification but worked quite well. Not sure if anyone makes a kit or not. You can piece together your own with IC piping, that is what i am doing with my new 3.5" intake i need.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top